Hallo zusammen,

Here is a 6x6 chassis I am working on. Hope you will like it.
Most parts are CNC. Some parts are 3D printing then casting.


Gruß
Sam

Front axle detail...

I want to make the chassis and parts in small production. Before that I would like to have some evaluation or review.
I have 3 sets to give out for free in this forum. One set will include 1x front axle, 2x rear axle, 1x gearbox and 1x frame.
If you are interested in, please send me an email to sangyue@gmail.com. Applicants will be processed on a first-come-first-served basis.

Request to the applicants:
1.Experienced user(give me some picture or video of your previous work)
2.Have time to do the evaluation and give feedback and suggestion.

Hi Sam,
your work looks absolute brillant!

What different revolutions did you realise with the gear changing in the 6x6 chassis ?


best regards,

Siegfried

Wow wow, great Job!

Hi,

the parts looks really good. I'm very impressed.

Nils

4x4 chassis in test...

Some M0.2 gears in small production...

add some front axle detail

Looks like lasermelted brass parts? nice work except the steering angle. I know that the angle is difficult but there should be possibe more than 40-45 degrees. All wheel drive without a differential makes any car or truck go wiiide turns... so you will need a better steering angle to correct this fact...

A great job.
I can only say ... Wow!

Want to get these wonderful "golden works" really hide under airbrushet color?

Edit:
You write "Some M0.2 Gears in small production ..." ...

Some gears are on the pictures to see Asian symbols.
If the parts are ordered from the Asian region or have you even produced the gears and worm?

Again Edit:

On this picture, a shift lever can be seen.
There will be a all-wheel drive to individually switch?


Sorry for my English maybe something twisted, my last lesson was about 30 years ago

Thanks. You get the point! All wheel drive do need a big steering angle. I did not find a good solution yet. Any suggestion?
Currently the sterring parts are 3D printed in wax. Then using the wax model to make plaster mould. After that using the plaster mould to make the parts in brass.

Currently if I need a big steering angle, I will us my etched axle. You could find the pictures below. Previous I developed for 1/87 and 1/72 model.

Hello do you have any DYI KITS to sell anymore? I want to buy :)